Raspberry Pi 3A+ Case

Simple case for the Raspberry Pi Model 3A+. No screws, no joints, just print and assemble.

10.10.2021

General informations

This is a case for Raspberry Pi Model 3A+. The dimensions of the case are 72 mm x 60 mm x 20 mm. It consists of two parts (a base and a lid) and has been designed to be fully covered with only cutouts for ports. It's easy to print and assemble. It doesn't require any additional screws or joints.
It fits Raspberry Pi 3 Model A+ and Raspberry Pi 1 Model A+.

Recommended print instructions for 0.4 mm nozzle

layer width: 0.4 mm,
layer height: 0.2 mm,
perimeters: 2,
solid layers: 5.

Assembly instructions:

Insert microSD card into Raspberry Pi.
Insert Raspberry Pi into the base. Side with HDMI, microUSB and mini Jack ports should be inserted first.
Assembly lid. A little connector should be inserted in the place where the USB port is located.

The lid should fit quite tight, but it should also disassemble from the base without using too much force.

Optional modifications:

The case can be easily modified even in the slicer. You can easily cut holes for GPIO pins, fans, air flow or various decorations according to your preferences.